beautypg.com

Analog Way Axion2 User Manual

Page 23

background image

21

4/

Press Black to adjust the levels of black for your Soft Edge. On

the Black tab, select the slave device you wish to work on, and

rotate the corresponding knobs to determine black levels for

your Soft Edge.

5/

Press the Blending tab to fine tune your Soft Edge. Select

a device in the dropdown menu, then, by rotating the

corresponding knobs, position the X and Y points of the

Blending curve, and increase or decrease their values to obtain

the desired onscreen balance for your Soft Edge.

6/

Press Pattern to go to the Patterns tab, and select the

appropriate patterns to setup and fine tune your Soft Edge

image. Choose amongst None, V. (vertical) Grey Scale, H.

(horizontal) Grey Scale, V (vertical) Color Bars, H. (horizontal)

Color Bars, Grid, SMPTE, Burst, Centering and Covering.

* TIP * : To configure your Soft Edge properly, you will probably need

to generate several types of patterns. Some patterns are dedicated

to video projector setup (like Grid or Centering), where others are

designed to adjust image blending (like Burst or Covering). Simply

select the pattern you want to use at any given stage, adjust your

settings, and return to the Patterns tab to change pattern for further

adjustments, or to remove it from your screen.

Soft Edge Setup

The Edit Soft Edge tab will be available only if the connected slave

device is being used in Embedded Soft Edge mode (for example a

Di-VentiX II) or if several devices are being used in Mixer Soft Edge

mode.

* TIP * : For more details on Soft Edge Blending, please refer to the

Soft Edge Blending chapter of this manual

1/

On the Screen Setup page of the

Axion2

, press Edit SoftEdge.

2/

On the Soft Edge Setup page, you will find several tabs to

control and adjust your Soft Edge. Press on Soft Edge Type to

choose the type of Soft Edge to apply (horizontal or vertical).

You can also position the devices within the screen by scrolling

with the appropriate knob left or right.

3/

Press the Covering tab to control the amount of Soft Edge

covering you need (indicated in pixels). By rotating the

corresponding knob, increase (right) or decrease (left) the

amount of image covering on your Soft Edge.