beautypg.com

Analog Way Axion2 User Manual

Page 22

background image

20

The Edit Audio tab will give access to audio in/out parameters such

as levels, balance or volume.

The Edit Sources tab allows to map device inputs, logos or frames to

[

SOURCE]

buttons on the

Axion2

front panel.

1/

On the Screen Setup page of the

Axion2

, press Edit Sources.

The buttons in the Source Preview section of the

Axion2

will

light up, allowing you to select the source you wish to work on.

2/

Select the source you wish to parameter, then press Edit to

give the source a new name if you wish.

* TIP * : If you are working with a matrix, you can map matrix

inputs to sources, assuming you have defined links between

the matrix and your device in the Edit Inputs page (see the

Input Configuration chapter and the Working With A Matrix

chapter).

3/

The Enable checkbox allows you to activate (default) or de-

activate sources. De-activating a source will result in a greyed

button on the

Axion2

front panel.

Audio configuration

Source configuration

1/

On the Screen Setup page of the

Axion2

, press Edit Inputs.

2/ Select the input you wish to parameter, then select the plug

type, and the type of signal. The status box (by the Select Input

dropdown menu) will display the image resolution and rate.

3/

Press the

[EDID]

button to select the EDID format required.

4/

Press the

[

AUDIO MAPPING]

button to map an audio input to

a video input.

5/

Press the

[MATRIX MAPPING]

button

to map your matrix outputs

* TIP * : If you are working with a matrix, you can route your image

through the matrix via the dropdown Linked To Matrix and Matrix

Output (see also Working With a Matrix) in the Matrix Mapping Tab.

6/

Press the

[

OK]

button to confirm input settings and return to

the Screen Setup page.

Input configuration

The Video Out tab will be available only if the slave device has an optional

video card installed (for example a

Di-VentiX II with option VO-8044).

1/

In the Screen Setup page of the

Axion2

, press Edit Video Out.

2/

Select the display mode for the slave device video out card,

then select the output format (resolution), output rate, enable/

disable HDCP.

3/ Press Pattern to generate a pattern on the screen/device

plugged to the slave device video out card if you wish to check

the video Out setup.

4/

Press the

[

TYPE]

button to select the type of signal required.

5/

Press the

[ADJUST]

button to adjust the gamma setting via the

corresponding knob.

6/

Press the

[

OK]

button to confirm and return to the Screen

Setup page.

Video Out configuration