Analog Way Axion2 - Manual (Page 24)

22
The Image Settings page allows you to fine tune the source image of
any input you have previously entered into your Screen.
* TIP * : You can access this page in show (cf. Source Settings
chapter).
1/ On the Screen Setup page of the Axion2 , press Image Settings.
The Image Settings page will give access to different settings
depending on whether the selected source is a digital or an
analog source.
2/ Select the source you wish to work on. Buttons in the Main/
Preview section will light up, indicating the sources are
available.
3/ Select the Adjust, Advanced, Pos/Size, Optimize, Aspect
Ratio, Zoom or Keying tabs to adjust the relevent settings of
your source image by rotating the corresponding knob, to fine
tune your source.
4/ When you are satisfied with your image settings, press the
[ OK] button to return to the Screen Setup page.
The Logos/Frames page allows you to capture and store logos,
frames/mask frames and animations (see also Frame Background).
1/ On the Screen Setup page of the Axion2 , press Logos/Frames.
The buttons in the Main/Preview section of the Axion2 will light
up, allowing you to display the source you wish to capture. The
buttons in the Layout section and the Settings section will also
light up, and give you access to your logo or frame parameters.
2/ Select the source you wish to capture by pressing a [ MAIN ] /
[ PREVIEW] button (#1 to #12), then select the Logo type if you
wish to record a logo, or the Frame type if you wish to record
a frame. In this case, we will see how to record a logo. A white
rectangle will appear on screen to indicate the area to capture
as a logo.
3/ Select the memory you wish to store the logo/frame into (#1 to
#8) in the Memory Slot dropdown menu.
4/ In the Layout section, press the [ POS] button, and with the
help of the joystick, move the rectangle on screen to the area
where your logo is. Resize the rectangle outline to fit the logo if
need be, by pressing the [ SIZE] button then adjusting with the
joystick.
* TIP *: To move the source, rather than the outline rectangle itself,
press [SOURCE] button, and adjust size and position with the help of
the joystick as described in step 4.
Image Settings
Logos & Frames