Analog Way Axion2 User Manual

Page 33

To clear a Logo from your Screen, proceed as follows:
1/

Select the LOGO you wish to clear.

Press the

[

CLEAR]

button once. In the

Axion2

Settings

section, a message will be displayed at the bottom of the touch

screen to confirm your action. Press the

[CLEAR]

button again

to confirm. The PIP will disappear from the Preview output.

Press the

[

TAKE]

button to view the result on your Main output.

* TIP * : To clear all logos from your screen, press the [CLEAR

LOGOs] button rather than the [CLEAR] button.

Clearing a logo

Programming a Preset

5-7. WORKING WITH PRESET MEMORIES

The

Axion2

automatically detects that the correct software version is in use on the product that it is connected

to. If connecting the

Axion2

directly to your product make sure that you use an Ethernet crossover cable.

For programming a preset, here is the configuration to do:

#1- Select a Screen #1 to #6

#2- Create a layer with “Preset Edition” section

#3- Select a source

#4- Save the configuration of the Screen in a Preset.

=> Restart the steps #1 to #4 if several screens are associated to a Preset.

With the

Axion2

, you have up to 90 presets memory. Each preset memory can save, at the given time, the exact

situation for 6 screens.

To manage presets memory, just select your screen in the screen section, make your preset for each screen

and then press the

[SAVE TO PRESET]

button and choose your preset.

If you save in a memory which has already been used, you’ll have several choices for each screen: Save,

Overwrite, reset and No change. Check the box, according to your choice, then press

[OK]

to confirm and finally

save your preset.

For saving a Preset with black content, you must save an empty Preset.

In loading Mode, short press on a preset: loading of all information

saved into the memory and selecting only the relevant screens in

the Transition section.

In loading Mode, long press on a preset: Loading only the

information concerning the Screens selected in the Transition

section.

For cleaning a Preset (Memory): Save To Preset => Confirm the reset of the memory on the touch screen.

The check boxes are not automatically checked by the software.

The operator must confirm the action of erasing.