GLOBALSAT TR-206 - Manual (Page 61)

60
7.3.2 Reading Geo-fence setting
Command of reading geo-fence data is ‘L3’ and the report media is
defined by ‘K4’.
Command Codeword Parameters
L3 (id1,id2~id3,id4)
Example 1:
Read 1
st
~10
th
Geo-fence areas
GSC,132763902812736,L3(1-10)*04!
Example 2:
Read Geo-fence area 1,2,5~8 & 10.
GSC,132763902812736,L3(1,2,5~8,10)*44!
Message format for reading Geo-fence area:
GS g ,IMEI,T,S,id1=(type,upper_left_Lon,upper_left_Lat,right_bottom
_Lon,right_bottom_Lat[,StartTime,EndTime,weekday]),id2=(…),id3
=(…),…*Checksum!
About the parameters of reading geo-fence, please refer to the parameters of
setting geo-fence.
Example 1:
Report 1~5 coordinates of Geo-fence
GSg,132763902812736,1,0,1=(1,121305521,24999088,121308246,24997649,00,8
6400,7F),2=(1,121302452,25004397,121305285,25002842,00,86400,7F)*6D!
GSg,132763902812736,0,1,3=(1,121299427,25014101,121302345,25012545,00,8
6400,7F),4=(1,121301723,25022909,121305306,25021101,00,86400,7F)*6F!
GSg,132763902812736,2,2,5=(1,12146435,25009979,121466711,25008423,00,86
400,02)*5f!