GLOBALSAT TR-206 - Manual (Page 30)

29
2.8 Codeword of Command
Commands are used to control the device activity. A command message is
composed of one or several command codeword. Each command codeword can
incorporate configuration parameter setting. Please refer to section 2.4 for
message format. Command message could be sent by SMS or TCP or UDP.
Command’s Codeword
Codeword Parameters Description
M7 Set Standby Mode
M2 Set Periodic Mode
M3 Set On-Line mode
M4 Set Motion mode
M8 Set Off mode
N0 Set Timer
N1 Ping device
N2 Trigger vibration
N4 Enable Voice Monitor
N6 Enable Geo-fence
N7 Disable Geo-fence
N8 Enable Data logger
N9 Disable Data logger
Na Dismiss SOS alarm
Ne Dismiss Geo-fence alarm
Nh Dismiss low battery alarm
Ni Dismiss All alarm
L1 Read Configuration
Adding up to 1-5 parameters.
If parameter=(ALL), then all user
configuration data will be reported.
L3 Read Geo-fence
L4
Make TR-206 connect to
Server