IBM EGX-400 - Manual (Page 96)

92 Chapter 5 - The Teaching Feature
5-7. List of Commands
8 CUT-3
Function This moves the spindle head to the specified X, Y, and Z coordinates, moving all three axes simultaneously
(at the specified feed rate).
Value ❶ Feed rate (0 to 50 mm/s)
Value ❷ X, Y, and Z coordinates for the movement destination
This moves the spindle at the specified feed rate. It moves all three axes simultaneously to the specified X, Y, and Z
coordinates. Unlike [CUT-ZM] and [CUT-ZI], it effects linear movement to the specified X, Y, and Z coordinates. This
command has no function for rotating or stopping the spindle.
◆ Basic Screen
Specify the feed rate. Specifying [0] sets a speed of 0.5 mm/s. After you input the speed, press the [ENTER/PAUSE]
button to go to the settings at Detail Screen 1.
◆ Detail Screen 1
Specify the X, Y, and Z coordinates for the movement destination. At this screen you can use button operations to move
or rotate the spindle. You can decide on the movement destination as you verify the on-screen coordinate values and the
actual position. To set the present location of the spindle as the movement destination, press the [ENTER/PAUSE]
button. To cancel and return, press the [MENU] button.
◆ Detail Screen 2
This displays the X, Y, and Z coordinates of the set movement destination. Use this screen to verify the settings.
1:
8 CUT-3 50
to cancel
❶
◆ Basic Screen
X 1000 Y 1000
Z -500 8000RPM
X 1000 Y 1000
Z -500 Dest.
◆ Basic Screen
◆ Basic Screen
❷ ❷
❷