IBM EGX-400 - Manual (Page 83)

79 Chapter 5 - The Teaching Feature
5-3. Correcting a Sequence
Revising a Saved Sequence
You can call up a saved sequence, revise it, and save it again.
Calling Up and Revising a Sequence
1 Press several times to display the screen
shown at right, then move the blinking cursor
to [TEACHING]. Press
. Move the blink-
ing cursor to [EDIT], then press .
2 Press to move the blinking cursor
to [No]. Press .
3 Turn the dial to choose the sequence you want
to revise. Press
.
The sequence editing screen appears.
4 Use the same procedure described earlier in
"If You Make a Mistake in Input" to revise the
sequence.
5 Press and hold for a short while (1 sec-
ond or longer), then press .
6 Turn the dial to choose the file to overwrite, then
press
.
7 Make sure that it's okay to overwrite, then
press
.
If you want to cancel the save and overwrite operation,
use
to move the blinking cursor to [No],
then press .
Select File
I nt. TEST
Edit New File ?
Yes
N o
I/O OTHERS
T EACHING SELF
RUN DELETE
E DIT SETTING
Save Sequence ?
Y es No Cancel
Select File
I nt. TEST
OverWrite File ?
Y es No
The [Int.] to the left of the file name means the sequence
has been saved in the built-in memory. Sequences saved
on a memory card are displayed with [Ext.].