IBM EGX-400 User Manual
Page 52
48
Chapter 3 - Preparations
3-4. Cutter Installation Method 3 (Diamond Scraper)
2. Menu Settings
5
Fully loosen the lock nut.
6
Use the menus to set [AUTO Z CONTROL] to ON.
(1) Press
several times to display the screen shown at right.
(2) Press
to move the blinking cursor to [OTHERS], then press
.
(3) Press
several times to display the screen shown at right.
(4) Press
to move the blinking cursor to [ON], then press
.
7
Use the menus to set [REVOLUTION] to OFF.
(1) Press
several times to display the screen shown at right.
(2) Press
to move the blinking cursor to [OTHERS], then press
.
(3) Press
to move the blinking cursor to [OFF], then press
.
8
Press
several times to return to the top screen.
Be sure to loosen the lock nut.
X 0 Y 0
Z 0 8000RPM
I/O
O
THERS
TEACHING SELF
REVOLUTION
ON
AUTO Z CONTROL
I/O
O
THERS
TEACHING SELF