IBM EGX-400 - Manual (Page 73)

69 Chapter 4 - Performing Cutting Using a Computer
4-4. Executing Cutting Data Saved on a Memory Card
Importing and Executing Memory-card Data
To operate the machine using cutting data saved on a memory card, follow the steps below.
Importing and Executing Data
1 Insert the memory card on which cutting data
is saved into the memory-card slot.
2 Press several times until the screen
shown at right appears. Make sure the blinking
cursor is at [RUN], then press
.
The screen for selecting the file appears.
3 Turn the dial to display the file name for the
cutting data that you want to import.
Press
.
The cutting data is imported and operation starts.
There may be a slight delay of several seconds to several dozen seconds until
the file-selection screen appears. During this time, do not try to remove the
memory card or switch off the power.
R UN
Select File
OUTPUT03.PRN
The execution of cutting data is exactly like operation when commands are received from a computer. Coordinate values are
displayed during execution, and the pause menu is also available. Make the settings for the home position, the Z0 position, and
cutting parameters using the same procedures as for when receiving commands from a computer.
Now Processing...