Requirements for saving cutting data – IBM EGX-400 User Manual
Page 69
65
Chapter 4 - Performing Cutting Using a Computer
4-4. Executing Cutting Data Saved on a Memory Card
Working with Cutting Data on a Memory Card
You can take cutting commands sent from the computer and save them as data. You can then save this data on a memory
card and import it into the machine. This means that you can receive data with a memory card in exactly the same way as
receiving commands from a computer via a connector cable.
This lets you distribute cutting data using just a memory card, making it possible to operate a number of machines in
locations where no computer is available.
Requirements for Saving Cutting Data
To save cutting data on a memory card, you use a commercially available memory-card writer.
☞
See p.31 "Memory-card Writers You Can Use"