Installing the battery – HP R707 User Manual

Page 14

HP Photosmart R707 User’s Manual

Installing the Battery

Your camera can use either a rechargeable HP Photosmart R07

lithium ion battery (L1812A) or a disposable Duracell

CP1

battery.

NOTE

If a rechargeable battery was shipped with your

camera, it will be partially charged, but you should fully

charge it before using it the first time. You can charge the

battery while it is in the camera. See

If the Battery/Memory card door is already open, skip this

step and go on to step 2.
Hold the camera with the bottom

facing up, and the front of the

camera facing you. Then slide the

Battery/Memory card door on the

bottom of the camera away from

you, toward the back of the

camera.

Insert the battery in the larger slot

as shown, and push it in until the

latch catches.

Close the Battery/Memory card

door by pushing the door down

and then sliding the door toward

the front of the camera until the

door latches.

To remove the battery from the camera, first turn the camera

off. Then open the Battery/Memory card door, release the

battery latch, tilt the camera, and the battery will slide out of its

slot.