HP R707 - Manual (Page 13)

Chapter 1: Getting Started 13
Installing a Memory Card (Optional)
If you do not have a memory card, skip this section and go on
to the next section, Installing the Battery on page 14. Your
camera contains internal memory that allows you to store
images and video clips. However, you can use a memory card
(purchased separately) instead to store images and video clips.
For more information about supported memory cards, see
Storage on page 179.
When you install a memory card in the camera, all new
images and video clips are stored on the card. The camera’s
internal memory is only used when there is no memory card in
the camera.
1 Hold the camera with the bottom
facing up, and the front of the
camera facing you. Then slide the
Battery/Memory card door on the
bottom of the camera away from
you, toward the back of the
camera.
2 Insert the memory card in the
smaller slot with the notched side
of the card going in first, as
shown. Make sure the memory
card snaps into place.
3 Leave the Battery/Memory card
door open and go on to the next
section, Installing the Battery on page 14.
To remove the memory card from the camera, first turn the
camera off. Then open the Battery/Memory card door, press
down on the top edge of the memory card, and it will spring
outward from the slot.