Resetting the camera – HP R707 User Manual

Page 124

124

HP Photosmart R707 User’s Manual

Resetting the Camera

If your camera does not respond when you press any buttons,

try resetting the camera as follows:

Holding the camera upside down with the back of the

camera facing you, open the battery/memory card door on

the bottom of the camera.

Remove the battery from the camera, and make sure the

HP AC power adapter is not connected to the camera.

The Reset switch is the

small hole located above

the battery slot, as shown.

Press the straightened end

of a paper clip into the

Reset switch until the

switch is depressed, and

hold it down for

approximately three

seconds, then remove the

paper clip. The camera is

now reset.

Reinsert the battery and close the battery/memory card

door. You may now use the camera again.