HP 220240 - Manual (Page 21)

Table 1–2: Printer Components: Rear/Left-Side View
Component Function
1. Power Switch Powers the printer on or off. Pressing ‘‘ | ’’ turns
power on; pressing ‘‘O’’ turns power off. To ensure
that data is not lost, always be sure the display reads
00 READY and the Data indicator is off before you
power off the printer. See Section 2.1 and Section 2.2
for additional information about powering the printer
on and off.
2. Rear Output Tray The rear output tray is selected when you are using
certain types of print media, such as transparencies,
labels, and envelopes. It can also be used when you
want printed output to be stacked faceup. Refer
to Section 2.6.2 for information about choosing the
different output trays.
3. Memory Board Access Cover Additional RAM (random-access memory) can be
added to the printer in 1, 2, or 3 MB capacities.
This access cover allows you to easily install the
extra memory board. Refer to the documentation that
comes with the optional memory board for installation
instructions.
4. Paper Jam Access Cover Opening this access cover allows you to remove paper
jammed in the lower paper path. See Section 6.7 for
more information about clearing paper jams.
5. Parallel (Centronics)
Interface Cable Connector
This connector is used if the interface cable from
the host computer is a parallel cable. See the
DEClaser 2200 plus Printer Installation Guide for
more information about connecting the printer to your
computer.
6. Serial (RS232C)
Interface Cable Connector
This connector is used if the interface cable from
the host computer is a serial cable. See the
DEClaser 2200 plus Printer Installation Guide for
more information about connecting your computer to
the printer.
7. Power Cord Receptacle This is where the power cord is connected to the
printer.
1–4 Operator’s Guide