HP 220240 - Manual (Page 134)

Table 6–4: Software Error Messages
Message Meaning Corrective Action
20 PAGE FULL The page buffer is over-
flowing with data.
Clear fonts from memory after each
job.
Assign one or two full-page bitmap
areas in memory to handle the complex
data (see Section 4.5.5.3).
Add additional RAM.
21 COMPLEX DATA There is complicated
print data that the
printer cannot handle.
Assign one or two full-page bitmap
areas in memory to handle the complex
data (see Section 4.5.5.3).
22 LINE ERROR The receiving buffer is
overflowing with data.
Enable a handshaking protocol to
regulate data flow (see Section 4.5.6.4,
Section 4.5.6.5, and Section 4.5.6.6).
Ensure that the host, the printer, and
any other devices that are connected
(such as print servers) all have the
same type of handshaking protocol
enabled.
23 MEMORY FULL Memory cannot accept
additional downline load-
ing of fonts into memory.
Clear fonts from memory after each
job.
Reallocate less bitmap page memory
space (Section 4.5.5.3).
Add additional RAM.
24 FULLPAINT REJ Full paint mode is not
allowed due to lack of
memory space.
Clear fonts from memory after each
job.
Add additional RAM.
26 MEMORY FULL RAM space is full. Clear fonts from memory after each
job.
Add additional RAM.
40 LINE ERROR An error has occurred
in the communication
circuit.
Check the interface parameters (Sec-
tion 4.5.6).
Check the integrity of lines; be sure
cables are properly shielded and that
all ground screws are in place.
41 PRINT CHECK A misprint has occurred. Perform the error skip procedure
(Section 6.1).
6–6 Operator’s Guide