HP DL980 G7 - Manual (Page 24)

Operations 24
CAUTION: Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
To remove the component:
1. Power down the server (on page 22 ).
2. Extend the server from the rack (on page 22 ).
3. Open the locking latch, slide the access panel to the rear of the chassis, and remove the access panel.
If the locking latch is locked, use a T-15 Torx screwdriver to unlock the latch.
Remove the upper or lower processor memory drawer
or processor memory drawer blank
1. Power down the server (on page 22 ).
2. Release the latches on the release lever.
3. Lower the handle, and then extend the processor memory drawer from the server until the release
latches catch.
4. Firmly holding the processor memory drawer, press the release buttons and then remove the drawer
from the server.