Heath Zenith DualBrite Triple Halogen Motion Sensing Light 5598 - Manual (Page 6)

6 598-1314-00
trOuBLeshOOting guiDe
If you experience a problem, follow this guide.
syMptOM pOssiBLe cause sOLutiOn
Lights will not come
on. 1. Light switch is turned off.
2. Lamp is loose or burned out.
3. Fuse is blown or circuit breaker is turned
off.
4. Daylight turn-off is in effect.
5. Incorrect circuit wiring, if this is a new
installation.
1. Turn light switch on.
2. Check lamp and replace if burned out.
3. Replace fuse or turn circuit breaker on.
4. Recheck after dark.
5. Verify wiring is correct.
Lights come on in
daylight. 1. Light control may be installed in a relatively
dark location.
2. Light control is in TEST.
1. The fixture is operating normally under these
conditions.
2. Set control switch to 1, 5, or 10 minutes.
Lights come on for no
apparent reason. Light control may be sensing small animals or
automobile traffic. Reduce sensitivity.
Lights stay on continu-
ously. The sensor may be picking up a heat source
like an air vent, dryer vent, or brightly painted,
heat-reflective surface. Reduce sensitivity.
Lights flash on and
off. Light control is in the TEST mode and warm-
ing up. Flashing is normal under these conditions.
technicaL service
please call 1-800-858-8501 (english speaking only) for assistance before returning
product to store.
If you experience a problem, follow this guide. You may also want to visit our Web site at: www.desatech.
com. If the problem persists, call* for assistance at 1-800-858-8501 (English speaking only), 7:30 AM to 4:30
PM CST (M-F). You may also write* to:
DESA Specialty Products
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service Specialty Products
* If contacting Technical Service, please have the following information available: Model Number, Date of
Purchase, and Place of Purchase.
no service parts available for this product
Five year LiMiteD Warranty
This is a “Limited Warranty” which gives you specific legal rights. You may also have other rights which vary from state to state or province
to province.
For a period of five years from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected
at no charge to you.
not covered - Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other expendable
items are not covered by this warranty. Unauthorized service or modification of the product or of any furnished component will void this
warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation, setup time, loss of use, unauthorized
service, or return shipping charges.
This warranty covers only DESA Specialty Products assembled products and is not extended to other equipment and components that a
customer uses in conjunction with our products.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY,
REPRESENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT FOR ANY PARTICULAR PURPOSE
OR USE, AND SPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES.
REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY ON THE
PART OF DESA SPECIALTY PRODUCTS FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUD-
ING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. Some states or provinces
do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
Proof of purchase is required for warranty claims.