Heath Zenith DUAL BRITE 598-1041-04 - Manual

Test 5 Sec x x
Auto 1, 5 or 10 Min x
Manual To Dawn* x
Accent 3,6 Hr, to Dawn x
Mode: On-Time Works: Day Night
Motion Sensing
Cast Aluminum
Lantern for
Canadian Tire
Features
• Light comes on when motion is detected.
• Automatically turns light off.
• Dusk Accent lighting.
• Photocell keeps the light off during day-
light hours.
Requirements
• The Light Control requires 120 volts AC.
• If you want to use Manual Mode, the con-
trol must be wired through a switch.
• Some codes require installation by a
qualified electrician.
© 2004 DESA Specialty Products™ 598-1041-04
OPERATION
* resets to Auto Mode at dawn.
Set the ON-TIME switch
on the bottom of the cover
plate to TEST.
TEST
TEST 1 5 10 MIN
AUTO
Set ON-TIME switch to 1,
5, or 10 minutes.
TEST 1 5 10 MIN
MANUAL MODE
1 Second
OFF then...
Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for
one second then back on to
toggle between AUTO and
MANUAL MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.
... back on.
Mode Switching Summary
Dual Brite ™ Dimmer Control
Light comes on half bright for selected time
after dusk (3 hr., 6 hr., until dawn). If motion
is sensed, the light turns on full bright for the
ON-TIME (1, 5, or 10 minutes) then returns
to dim mode.
This package includes:
• Lantern
• Easy to use universal mounting bracket
(X-Bar)
• Mounting hardware
• Wire nuts
ON-TIME
Switch at 1,
5, or 10
minutes
Flip light
switch off for
one second
then back on*
* If you get confused while switching modes,
turn the power off for one minute, then back on.
After the calibration time the control will be in
the AUTO mode.
MANUAL MODE
AUTO
TEST
Note: When first turned on wait about 1 1 /
2
minutes for the circuitry to calibrate.