HP Q153090901 - Manual (Page 43)

INQUIRY 12h
C
omm
an
ds
43
Vendor Specific data may be sent after the Product Revision Level.
Product Revision Level A vendor-specific string of four ASCII characters: “
CNNV
”:
•
C
is the codename (
G
for a Gen 3 SCSI drive,
L
for Gen 3 FC drive)
•
NN
are two digits that indicate the build of the variant.
•
V
is an ASCII character representing the OEM variant of the code. “
D
” is the
standard distribution variant.
WORM Version The version of WORM supported.
WORM 1 The drive supports the LTO WORM specification.
OBDR string “
$DR-10
” if the drive supports Tape Disaster Recovery.
Clocking 0 For FC drives.
3 For SCSI drives, indicating that the drive supports both ST and DT
transfers.
QAS 0 The drive does not support Quick Arbitration and Selection.
IUS Information Units
0 Not supported for all drives other than SCSI.
1 Supported for SCSI drives.
Version Descriptor These fields can be used to identify up to eight standards to which the drive
conforms. The values supported are listed below.
For SCSI drives, it is recommended that the first version descriptor is used for the
SCSI architecture standard, followed by the physical standard, if any, followed
by the SCSI protocol, followed by the appropriate SPC version, followed by the
device type command set, followed by the secondary command set, if any.
The following are the SCSI version descriptors:
Value Standard
1
2
3
4
5–8
005Ch
0B56h
0300h
037Dh
0000h
SAM2 ANSI INCITS.366.2003
SPI4 ANSI INCITS.362:2002
SPC3
SSC2 ANSI INCITS
not used
The following are the FC version descriptors:
Value Standard
1
2
3
4
5
6
7
8
0054h
0917h
0D7Ch
0DA0h
131Bh
1320h
0277h
021Ch
SAM-2 T10/1157-D rev 23
FCP-2 ANSI NCITS.332:1999
FC-AL-2 ANSI NCITS.350:200x
FC-FS (no version claimed)
FC-Tape T11/1315 revision 1.17
FC-FLA (no version claimed)
SPC-2 ANSI NCITS.351:2001
SSC ANSI NCITS.335:2000