HP Q153090901 - Manual (Page 181)

WRITE ATTRIBUTE 8Dh
C
omm
an
ds
181
Parameter list format:
The parameter list has the following format. The attributes should be sent in ascending
numerical order. For details of attribute data see “MAM attribute data” on page 115.
If the parameter data contains an attribute with an Attribute Length of zero, one of the following
actions will occur:
• If the attribute is read-only or unsupported, no attributes are changes. The command fails,
returning CHECK CONDITION with ILLEGAL REQUEST sense and additional sense of 2600h
(invalid field in parameter list).
• If the attribute can be written to, it is deleted and will not be returned after a subsequent
READ ATTRIBUTE command.
• If the attribute does not exist, the command cannot affect it. This is not considered an error.
Write Attribute specific status:
The command will be terminated and will return CHECK CONDITION under the following
circumstances:
7 6 5 4 3 2 1 0
0 (MSB)
Parameter Data Length (n − 3)
3 (LSB)
4
Attribute 1
a
: :
m
Attribute x
n
Parameter
Data Length
This is not mandatory and will be ignored by the device server because it duplicates the
Parameter List Length.
Description Sense Key Additional Sense
There is no cartridge present in the drive , not even
partially loaded .
NOT READY 3A00h (medium not present)
The MAM is not accessible even though there is a tape
in the drive. None of the attributes are changed.
MEDIUM
ERROR
0410h (MAM not
accessible)
The MAM has failed (for example from a bad
checksum)
MEDIUM
ERROR
0C0Bh (MAM write error)
T he Parameter List Length results in the truncation
of an attribute.
ILLEGAL
REQUEST
1A00h (parameter list length
error)
The combination of Volume Number and Partition
Number is not valid.
ILLEGAL
REQUEST
2400h (invalid field in CDB)