HP 20/700 - Manual (Page 113)

112 Operating in Automated Mode Chapter 4
Exporting Data Cartridges through the CAP
To export data cartridges through the CAP:
1. Press the [CAP A] or [CAP B] button on the operator panel to open the
CAP.
2. Remove or pull down the magazine and remove the cartridges and store
them outside the tape library.
3. Repeat these steps until you have removed all the required cartridges.
4. Press the [CAP] button to close the CAP
5. Refer to your console and your software documentation for further
instructions.
Manually Cleaning a Drive
If you have not enabled the Auto Clean function on the library, then the library
status screen will display CLEAN NEEDED whenever a drive requires cleaning.
To manually clean this drive:
1. Press the [CAP] button on the operator panel to open the CAP.
2. Insert the required cleaning cartridge into the CAP.
3. Press
the [CAP] button to close the CAP.
4. Press the [MENU] button until the Main Menu displays.
5. Press the arrow buttons until the cursor underscores DIAGNOSTICS.
6. Press
the [SELECT] button.
The panel displays the Main Diagnostics Menu (see Figure 13 on page
49).
7. Press the arrow buttons until the cursor underscores DRIVE
DIAGNOSTICS.
8. Press the [SELECT] button.
The screen will display a list of all installed drives.
9. Use the arrow buttons to highlight the desired drive.
10. Press the [SELECT] button.
The Diagnostics Drive Menu appears.
11. Press the arrow buttons until the cursor underscores CLEAN DRIVE.