HP 20/700 - Manual (Page 104)

Chapter 4 Operating in Automated Mode 103
Chapter 4
The following status messages might appear on the Personality Module Info
screen:
Table 11 Personality Module Status/Info Screen
Message Message Message Message Explanation Explanation Explanation Explanation
Status NOT PRESENT No personality module is attached to the logic card.
Note: The personality module is not needed to enable
WBLA.
Type NORMAL The factory-installed personality and vendor information are
in effect.
VERSION The version number for the personality module. If a
personality module is not present, this is the version of the
vendor information (factory set at “0”).
LIBRARY VENDOR ID The identity number for the library vendor (factory set at “1”).
LIBRARY VENDOR
NAME
The name of the library vendor (factory set as “HP”).
LIBRARY PRODUCT
NAME
If TYPE is NORMAL, this is the product name assigned by the
library vendor (factory set as “A5597A”).
SCSI VENDOR NAME The library vendor name reported on the SCSI interface
(factory set as “HP”).
SCSI PRODUCT NAME The library product name reported on the SCSI interface
(factory set as “A5597A”).
Horizon ENABLED The Web-Based Library Administrator product is enabled.