HP 20/700 - Manual (Page 107)

106 Operating in Automated Mode Chapter 4
Caution Possible damage to the hand assembly. Remove the magazine’s
retention cover before loading the magazine into the CAP.
4. Return the magazine to its closed position.
5. Press
the [CAP] button on the operator panel to close the CAP.
6. Press the [MENU] button to return the display to the Main Menu.
7. Press the arrow buttons until the cursor underscores CLEANING INFO.
8. Press the [SELECT] button.
The panel displays the Cleaning Info menu (see Figure 12 on page 47).
9. Press the arrow buttons until the cursor underscores IMPORT CARTRIDGE.
10. Press the [SELECT] button.
The Import Clean Cartridges screen appears, which lists all reserved cell
cleaning cartridges by domain (or drive type), and VOLSER.
11. Select the cleaning cartridges you want to import by:
a. Moving the cursor to the desired cartridge entry on the list
b. Pressing
the [SELECT] button. A selected cleaning cartridge is then
highlighted (in reverse video)
c. Repeating Steps a and b until you have selected all the cartridges you
want to import
Note There is no “undo” available on this menu. If you select a
cartridge by mistake, you must exit the menu by pressing the
[MENU] button. Then you must start again at Step 10.
12. Press the [SELECT] button to import the cartridges.