Hearth and Home Technologies GATEWAY - Manual (Page 7)

Heat & Glo • Gateway • 288-900 Rev. W • 10/08 7
2 2
Getting Started
Check building codes prior to installation.
• Installation MUST comply with local, regional, state and
national codes and regulations.
• Consult local building, fi re offi cials or authorities having jurisdic-
tion about restrictions, installation inspection, and permits.
CAUTION
Fire Risk
Explosion Risk
Keep appliance dry.
• Mold or rust may cause odors.
• Water may damage controls.
WARNING
A. Introducing the Gateway Fireplace
The Gateway fi replace is designed to operate with all ex-
haust gases expelled to the outside.
The information contained in this Installers Guide, unless
noted otherwise, applies to all models and gas control
systems. Gas fi replace diagrams, including the dimensions,
are shown in this section.
Warranty
The Heat & Glo Warranty will be voided by, and Heat &
Glo disclaims any responsibility for, the following actions:
• Installation of any damaged fi replace or vent system
component.
• Modifi cation of the fi replace or vent system.
• Installation other than as instructed by Heat & Glo.
• Improper positioning of the gas logs or the glass door.
• Installation and/or use of any component part not man-
ufactured and approved by Heat & Glo, not withstand-
ing any independent testing laboratory or other party
approval of such component part or accessory.
ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE
HAZARD.
Pre-install Preparation
This gas fi replace and its components are tested and safe
when installed in accordance with this Installers Guide.
Report to your dealer any parts damaged in shipment,
particularly the condition of the glass. Do not install any
unit with damaged, incomplete, or substitute parts.
The vent system components are shipped in separate
packages. The gas logs are shipped in the fi replace and
must be on unwrapped before fi ring the unit.
Read all of the instructions before starting the
installation. Follow these instructions carefully during
the installation to ensure maximum safety and benefi t.
Failure to follow these instructions will void the owner’s
warranty and may present a fi re hazard.
When planning a fi replace installation, it’s necessary to
determine:
• Where the unit is to be installed.
• The vent system confi guration to be used.
• Gas supply piping.
• Electrical wiring.
• Framing and fi nishing details.
• Whether optional accessories — devices such as a fan,
wall switch, fresh air kit or remote control — are de-
sired.
If the fi replace is to be installed on carpeting or tile, or
on any combustible material other than wood fl ooring, the
fi replace must be installed on a metal or wood panel that
extends the full width and depth of the fi replace.