Hearth and Home Technologies GATEWAY - Manual (Page 30)

Heat & Glo • Gateway • 288-900 Rev. W • 10/08 30
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Remove Grate Shipping Support
• Remove the log pack and hood, if applicable.
• Bend top retaining tab of grate shipping support into
vertical position (see Figure 12.1).
• Lift grate slightly upward with one hand so that the grate
clears the support.
• Slide shipping support to side, remove and discard.
• Lower grate onto refractory.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• When placing Glowing Embers
®
onto the burner care
should be taken so that the ports are not covered.
Place the dime-size ember pieces about 1/2 inch apart
near port holes in burner top, but not on or in between
the ports. For best performance do NOT place embers
on ports at rear of burner (see Figure 12.2). Failure to
follow this procedure will likely cause lighting and sooting
problems.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
Figure 12.2 Placement of Embers
INCORRECT
EMBER PLACEMENT CORRECT
EMBER PLACEMENT
FIRST
GRATE BAR
EMBER
MATERIAL
C. Clean the Appliance
Clean/vacuum any sawdust or construction debris that
may have accumulated inside the fi rebox or underneath
in the control cavity.
D. Accessories
Install approved accessories per instructions included with
accessories. See Service Parts List for appropriate acces-
sories. Refer to Section 16.
Figure 12.1
12 12
Appliance Setup
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
E. Lava Rock, Vermiculite, Rockwool/
Ember Placement
Explosion Risk.
• Follow ember placement instructions in manual.
• Do NOT place embers directly over burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
WARNING
WARNING