Epson Equity II - Manual (Page 87)

ROMBIOS Displays the computer’s ROM BIOS version
number.
SYSTAT Displays the system parameters.
These commands are easy to use. The ROMBIOS command displays
the ROM BIOS version number for your computer. When you type
ROMBIOS and press Enter, you see a message similar to this:
ROM BIOS Version 2.00
The SYSTAT command displays the system information you supply
when you run the Setup program. After you run Setup, you can type
SYSTAT and press Enter to display the system parameters.
See your MS-DOS manual for information regarding the use of
EXE2BIN, HDCACHE, HDSIT, and LINK.
Starting the Diagnostics
To start the diagnostics programs, follow these steps:
1. Turn off the computer and wait for a few seconds.
2. Place the reference diskette in drive A, and close the door of the disk
drive.
3. Turn on the computer.
When you turn the power on, the computer performs a self test and then
automatically starts the diagnostics program.
The Power-on Self Test
Whenever you turn on or reset the computer, the system performs a
built-in diagnostics program called the power-on self test. This test checks the
RAM (random access memory), keyboard, system board, and peripherals
before the computer begins normal operation.
If the self test finds a discrepancy between the equipment installed on the
computer and the equipment list maintained by the computer, the system
asks you to run the Setup program (on the reference diskette) to change the
equipment list.
For a complete description of the power-on self test and any error mes-
sages it may produce, refer to Appendix C.
Intro-2 Diagnostics