Epson Equity II - Manual (Page 45)

4. You can separate the sides of the cover from the bottom ledge of the
computer by pulling them outward slightly, as shown in Figure 4-3.
Figure 4-3. Remodeling the cover
5. When the back edge of the cover is a few inches away from the back
panel, you can lift the cover off. Set the cover aside.
Installing an Option Card
Figure 4-4 shows the six option slots in the Equity II+. Slot 6 contains
the parallel and serial interface and floppy disk controller card. Be sure to
install the video card in slot 5.
Slots 1,5, and 6 are designed for 8-bit option cards and the other three-
slots 2 through 4-are designed for 16-bit option cards. Figure 4-5 shows
both types of cards. As you can see, the 16-bit card has a second connector.
User’s Guide 4-3