Epson Equity II - Manual (Page 54)

Printer Problems
Your printer manual describes methods to solve most printer problems.
If your printer does not work correctly right after you install it, make sure the
printer has power and is properly connected to the computer. The printer
manual tells you how to connect your printer.
If you have printing problems, check the printer manual for the printer’s
DIP switch settings. The DIP switches on a printer help it communicate
properly with the computer.
Be sure your software is set up for your printer.
Option Card Problems
If you install an option card and get unexpected results, check the
following:
1.
2.
3.
4.
5.
6.
Is the option card installed correctly?
Did you follow the setup and operation procedures in the option card
instructions?
Did you set any necessary DIP switches or jumpers on the option card?
See your option card instructions.
Did you change any necessary jumper settings in the main unit? See
Appendix A, “Jumper Settings.”
If you added an external device, did you use the proper cable to connect
the peripheral to the port or option card connector on the back panel?
Did you perform any necessary post-installation setup procedures for the
operating system? Refer to the Diagnostics section in this manual, your
MS-DOS manual, or other software manual for instructions.
5-4 User’s Guide