Epson Equity II - Manual (Page 50)

Post-installation Setup
After you install an option card (and replace the main unit’s cover and
reconnect the power cord and peripherals), you may need to run the Setup
program on the reference diskette to update the configuration information.
For example, if you add a hard disk, you need to tell the computer that it has
the additional drive. See the Diagnostics section of this manual for instruc-
tions.
You may also need to add some commands in the configuration file on
your system disk. See your MS-DOS manual for instructions.
When you finish installing an option and reconfiguring the system, you
should test the option if possible. Some options come with their own test
programs, and you can test others using the diagnostics programs on the
reference diskette that came with the Equity II+. These include:
l
Expansion memory
l
80287 numeric coprocessor
l
Serial and parallel ports
l
Monitors and display adapters
l
Disk drives.
See the Diagnostics section of this manual for instructions.
4-8 User’s Guide