Zone b function, Multi-zone function, Remote controller – Onkyo TX-NR7100 9.2-Channel THX-Certified Network AV Receiver User Manual
Page 163: Display 163, Troubleshooting, Display
163
Troubleshooting
ZONE B function
Cannot output audio to ZONE B
•
To output audio to ZONE B, set the audio output destination for "Audio" - "Zone B" on Quick menu to "On (A+B)" or "On (B)" and also set
"2. Speaker" - "Configuration" - "Zone 2 Lineout" on the Setup menu to "Zone B".
Multi-zone function
Cannot ZONE-output the audio of externally connected AV components
•
To output audio from an externally connected AV component to ZONE 2, connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not
equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or analog audio cable. Also, the audio from externally connected AV
components can be output to ZONE 2 only when the audio is analog or 2 ch PCM signal. When the AV component is connected to this unit with
an HDMI cable, digital coaxial cable or digital optical cable, change the audio output of the AV component to the PCM output.
•
When video and audio via HDMI input are output to ZONE 2, set "1. Input/Output Assign" - "TV Out / OSD" - "Zone 2 HDMI" (
) to "Use"
on the Setup menu.
•
To output audio from an externally connected AV component to ZONE 3, use an analog audio cable for connection. Also, audio from externally
connected AV components can be output to ZONE 3 only when it is an analog audio signal.
Others
•
If the audio signal is from the NET input selector, the zone output is not possible for DSD audio signals.
Remote Controller
•
Make sure that the batteries are inserted with the correct polarity.
•
Insert new batteries. Do not mix different types of batteries, or old and new batteries.
• Make sure that the sensor of the main unit is not subjected to direct sunlight or inverter-type fluorescent lights. Relocate it if necessary.
•
If the main unit is installed in a rack or cabinet with colored-glass doors, or if the doors are closed, the remote controller may not work normally.
Display
The display does not light up
•
When the Dimmer function is working, the display may go dim. Press the DIMMER button, and change the brightness level of the display.
•
The display is turned off when the Pure Audio listening mode is selected.