Onkyo TX-NR7100 9.2-Channel THX-Certified Network AV Receiver - Manual (Page 139)

139
Setup Setup
7. Miscellaneous
„
3. Firmware Update
Change the settings for Firmware Update.
‰ Update Notice (Default Value: Enable)
Availability of a firmware update is notified via network.
Enable Notify updates
Disable Do not notify updates
‰ Version (Default Value: -)
The current firmware version is displayed.
‰ Update via NET (Default Value: -)
Press ENTER to select when updating the firmware via network.
• This setting cannot be selected if you do not have Internet access or there is
no updatable firmware.
‰ Update via USB (Default Value: -)
Press ENTER to select when updating the firmware via USB.
• This setting cannot be selected if a USB storage device is not connected or
there is no updatable firmware in the USB storage device.
• Wait for a while if "Firmware Update" cannot be selected. It can be selected
when the network function is activated.
„
4. Initial Setup
Make the initial setup from the setup menu.
• Wait for a while if "Initial Setup" cannot be selected. It can be selected when
the network function is activated.
„
5. Lock
Lock the Setup menu so that the settings cannot be changed.
‰ Setup Parameter (Default Value: Unlocked)
Lock the Setup menu so that the settings cannot be changed.
Locked The menu is locked.
Unlocked The menu is unlocked.
„
6. Factory Reset
All the settings are restored to factory defaults.
‰ Factory Reset (Default Value: -)
All the settings are restored to factory defaults.
Select "Start" and press ENTER.
• If "Factory Reset" is performed, your settings are restored to the default
values. Be sure to note down your setting contents beforehand.