Onkyo TX-NR7100 9.2-Channel THX-Certified Network AV Receiver - Manual (Page 119)

119
Setup Setup
2. Speaker
„
5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
• This setting can be selected when "Configuration" - "Height 1 Speaker" /
"Height 2 Speaker" is set to "Dolby Speaker".
‰ Distance from the ceiling (Default Value: 6.0 ft/1.80 m)
Set the distance between the Dolby Enabled Speaker and the ceiling. Select
between "0.1 ft"/"0.03 m" and "15.0 ft"/"4.50 m" ("0.1 ft"/"0.03 m" units).
• The unit of distance (ft/m) is displayed using the unit selected for the
"Distance" setting.
‰ AccuReflex (Default Value: Off)
You can enhance the reflection effect of Dolby Enabled Speakers from the
ceiling.
• The function is not effective if the listening mode is Pure Audio or Direct.
• The function is not effective if "Dirac Live" ( → p78 ) has been enabled.
Off When this function is not used
On When this function is used
„
6. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of different sound ranges for each speaker. You can set three
different equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to five bands for the Subwoofer and nine bands
for the other speakers.
‰ Front (Default Value: 0.0dB)
Center (Default Value: 0.0dB)
Height 1 (Default Value: 0.0dB)
Height 2 (Default Value: 0.0dB)
Surround (Default Value: 0.0dB)
Surround Back (Default Value: 0.0dB)
Subwoofer (Default Value: 0.0dB)
After selecting the speaker frequency from between "25 Hz" and "16 kHz" ("25
Hz" and "160 Hz" for Subwoofer) with the cursors / , adjust the volume of that
frequency between "-6.0 dB" and "+6.0 dB" with / .
• Depending on the input source or listening mode setting, the desired effect
may not be achieved.
(Height 1 Left, Height 1 Right, Height 2 Left, Height 2 Right , Surround Back):
• Depending on the use of the ZONE speakers, it may not be possible to select
this setting.
(Subwoofer):
• This cannot be selected if "Configuration" - "Subwoofer" is set to "No".