Rear panel – Onkyo TX-NR7100 9.2-Channel THX-Certified Network AV Receiver User Manual
Page 15
15
Rear Panel
8K
4K
8K
8K HDCP 2.3
11.
GND terminal
: Connect the ground wire of the
turntable.
12.
AUDIO IN jacks
: Input AV component audio
signals with an analog audio cable.
13.
12V TRIGGER OUT jack
: Connect a device
equipped with a 12V trigger input jack to enable
power link operation between the device and this
unit. (
14.
IR IN port
: Connect a remote control receiver
unit. (
15.
PRE OUT FRONT jacks
(European, Australian and Asian models):
Connect to a power amplifier. (
16.
SPEAKERS terminals
: Connect speakers with
speaker cables. (North American models support
banana plugs. Use a plug 4 mm in diameter. Y
plug connection is not supported)
17.
SUBWOOFER PRE OUT jacks
: Connect a
powered subwoofer with a subwoofer cable.
Up to two powered subwoofers can be
connected. The same signal is output from each
SUBWOOFER PRE OUT jack.
18.
ZONE 2 LINE OUT jacks
: Output audio signals
with an analog audio cable connected to an
integrated amplifier in a separate room (ZONE
2).
ZONE B LINE OUT jacks
: Simultaneously
output the same audio source as the speakers
(ZONE A) connected to this unit by connecting
this unit to wireless headphones, wireless
speaker transmitter, etc., using an analog audio
cable.
PRE OUT
FRONT