HP LaserJet Pro 4001dw Monochrome Wireless Printer - Manual (Page 51)

Set up job storage
Set up job storage in the print driver, insert the storage media (USB flash drive) in the printer, and verify
the feature is ready to use.
Before you begin, install the printer software if it is not already installed. Go to www.hp.com/support , click
Software and Drivers, and then follow the onscreen instructions to download the latest HP software.
When the print driver is installed, the Job Storage option is set to Automatic by default. The option is
located as follows:
● Windows: Devices and Printers > Printer Properties > Device Settings
● macOS: Printers & Scanners > Options & Supplies
To complete Job Storage setup:
1. Locate the rear USB port.
NOTE: On some models, the rear USB port is covered. Remove the rear USB port cover before
proceeding.
2. Insert the USB flash drive into the rear USB port.
Figure 4-1 Insert USB flash drive
A message displays on the control panel warning that the USB drive will be formatted. Select OK to
complete the procedure.
3. Open the print driver to verify the Job Storage tab is visible. If it is visible, the feature is ready to use.
From a software program, select the Print option, select your printer from the list of printers, and do
the following:
● Windows: Select Properties or Preferences. Click the Job Storage tab.
If the Job Storage tab is not showing, activate it as follows:
From the Start menu, open Settings, click Devices, and then click Devices and Printers. Right-
click on the printer name and click Printer Properties. Click the Device Settings tab, click on Job
Storage, and then select Automatic. Click Apply and OK.
● macOS: The print driver displays the Copies & Pages menu. Open the drop-down list, and then
click the Job Storage menu.
42 Chapter 4 Print