EAW DSA250 & DSA230 - Manual (Page 29)

5 . 6 I n i t i a l S e t - U p
5 . 6 . 1 V E R I F Y L O U D S P E A K E R O R I E N TAT I O N A N D P O S I T I O N
Using the DSAPilot, and with communications established with the
loudspeakers, click on each loudspeaker in DSAPilot. The LED in
both the DSAPilot graphic and on the actual loudspeaker will
illuminate. Ensure that the physical orientation and position of
each loudspeaker corresponds to that shown in the DSAPilot graphic.
See the DSAPilot help file for further information.
CAUTION: Incorrect orientation or cluster position will result in poor
to unusable performance.
5 . 7 A c o u s t i c a l I n s t a l l a t i o n
Adjustment of the signal processing and thus the acoustical performance
for each DSA Cluster is accomplished using the DSAPilot program.
Complete instructions for its use can be found in the DSAPilot Help file.
These are the basic tasks that need to be done using the DSAPilot:
1. Select each cluster configuration used in the system design
2. Assign the installed clusters to those selected in the DSAPilot
3. Set the Steering parameters for each cluster
4. Configure the audio input routing for each cluster
5. Set the user-adjustable gain, EQ, compression, or signal delay for
the inputs
6. Set the desired Power Saving operation
7. Save the final signal processing settings for the system to a file
29
LED INDICATOR
Figure 5.6 Identification LED