EAW DSA250 & DSA230 User Manual
Page 28
1. Install at least one of the supplied 1/4-20 X 3 in Retainer Bolt
with its lock washer through the side of either the top or bottom
Wall/Enclosure Bracket and snugly tighten. The bolt threads into a
weld nut on the side of the Wall Bracket. This Retainer Bolt prevents
the enclosure from being lifted off the Wall Brackets without first
removing the bolt. Note that the Retainer Bolt does not “clamp”
or support anything. It serves only to retain the enclosure on the
wall brackets, not to lock it into position.
2. Route cabling as required using the rear channels in the enclosures
extrusion.
3. Rotate the enclosure to the desired horizontal angle. Firmly tighten
each Enclosure Bracket Bolt to secure the enclosure in the desired
position.
28
1/4-20 X 3 LG
HEX HEAD SCREW
& LOCK WASHER
1/4-20 WELD NUT
Figure 5.5.9b Retainer Bolt Installation
ENCLOSURE BRACKET BOLT
CABLE CHANNELS
Figure 5.5.9c Cable Routing
Figure 5.5.9d Secure the Enclosure Position
- SB150zP (4 pages)
- MK5326 (2 pages)
- DCS2 (2 pages)
- KF930 (2 pages)
- MK8196 (2 pages)
- CIS65 (8 pages)
- DSA230 & DSA250 (2 pages)
- JF60z (6 pages)
- CR72 (2 pages)
- MQTD812 (2 pages)
- CB153X (2 pages)
- SMS4 (8 pages)
- FR159z 2D (1 page)
- CB259 (2 pages)
- DC2 (2 pages)
- SB1000zP (4 pages)
- 425017 (8 pages)
- SB150zR (4 pages)
- DCT2 (2 pages)
- DC4 (2 pages)
- MK5394 (2 pages)
- MQH1346e (2 pages)
- D S A 2 5 0 (44 pages)
- MQ1394e (2 pages)
- DCT1 (2 pages)
- KF650z 2D (1 page)
- Dual 12-Inch Horn Subwoofer KF940 (4 pages)
- UB22z (6 pages)
- MQ1215 (2 pages)
- SB180zP (4 pages)
- Ceiling-Mount System CP621 (6 pages)
- SB185C (2 pages)
- SB528zP (1 page)
- ASR695e (1 page)
- BH822e (2 pages)
- SB528zR (4 pages)
- KF920 (2 pages)
- MK8126 (2 pages)
- MK5366 (2 pages)
- SB48zP (4 pages)
- SB625zP (4 pages)
- SB180zR (4 pages)
- SB750zF (4 pages)
- SBX220 (2 pages)
- CR58 (2 pages)