Epson EpiqVision Ultra LS300 3600-Lumen Full HD Ultra-Short Throw Smart Laser 3LCD Projector (Black) - Manual (Page 71)

71
Status light Status and solution
Flashing orange Laser has a problem. Turn the projector off, unplug it, and contact
Epson for help.
A fan or sensor has a problem. Turn the projector off, unplug it, and
contact Epson for help.
Obstacle detection error. If there are no obstacles interfering with the
projection window, turn the projector off, unplug it, and contact Epson
for help.
Internal projector error. Turn the projector off, unplug it, and contact
Epson for help.
Parent topic: Solving Problems
Solving Image or Sound Problems
Check the solutions in these sections if you have any problems with projected images or sound.
Solutions When No Image Appears
Solutions When "No Signal" Message Appears
Solutions When Only a Partial Image Appears
Solutions When the Image is Not Rectangular
Solutions When the Image Contains Noise or Static
Solutions When the Image is Fuzzy or Blurry
Solutions When the Image Brightness or Colors are Incorrect
Solutions to Sound Problems
Solutions to Bluetooth Audio Problems
Parent topic: Solving Problems
Solutions When No Image Appears
If no image appears, try the following solutions:
• Check the status light to confirm the projector is operating normally.
• Press the Blank button on the remote control to see if the image was temporarily turned off.
• Make sure all necessary cables are securely connected and the power is on for the projector and
connected video sources.