Sony FE 100-400mm f/4.5-5.6 GM OSS Lens - Manual (Page 56)

Hint
The operation above is an example. For more details, refer to the operating instructions supplied with the computer.
To delete all Bluetooth pairing information, see “ Initializing the headset to restore factory settings ”.
Note
If pairing is not established within 5 minutes, pairing mode is canceled. In this case, set the headset into the charging case, and
start the operation again from step
.
Once Bluetooth devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
When a 9th device is paired.
The headset can be paired with up to 8 devices. If a new device is paired after 8 devices are already paired, the registration
information of the paired device with the oldest connection date is overwritten with the information for the new device.
When the pairing information for the headset has been deleted from the Bluetooth device.
When the headset is initialized.
All of the pairing information is deleted. In this case, delete the pairing information for the headset from the connected device
If Passkey (*) input is required, input “0000”.
The headset and computer are paired and connected with each other.
When the headset is placed in the charging case, the indicator (blue) on the charging case flashes slowly for about
5 seconds.
When you are wearing the headset, you will hear a notification sound from both headset units at the same time.
If they are not connected, see “
Connecting to a paired computer (Windows 8.1) ”.
If [LinkBuds] does not appear on the computer screen, try again from the beginning of step .
Select [LinkBuds], then select [Pair]. 5.
A Passkey may be called “Passcode”, “PIN code”, “PIN number”, or “Password”. *
56