Pairing cannot be done – Sony FE 100-400mm f/4.5-5.6 GM OSS Lens User Manual

Page 135

Wireless Stereo Headset

LinkBuds

Pairing cannot be done.

Bring the headset and the Bluetooth device within 1 m (3 feet) from each other.
When pairing for the first time after purchasing, initializing, or repairing the headset, the headset enters pairing mode
automatically if you remove the headset from the charging case. To pair a second or subsequent device, set the
headset into the charging case, and then press and hold the pairing button of the charging case for about 5 seconds
to enter pairing mode.
The headset cannot go into pairing mode if the headset is not set securely in the charging case, such as when the
fitting supporters are not properly attached to the headset. Make sure the headset is set securely in the charging
case.
When pairing a device once again after initializing or repairing the headset, you may be unable to pair the device if it
retains pairing information for the headset (iPhone or other device). In this case, delete the pairing information for the
headset from the device and pair them again.
Restart the connected device such as a smartphone or a computer you use, and pair the headset and the device
again.
Charge the charging case.
Set the headset into the charging case and close the lid of the charging case.
You may be able to resolve some issues by setting the headset into the charging case.
Reset the headset.
Initialize the headset, and pair the headset and the device again.

Replacing the fitting supporters

Resetting the headset

Initializing the headset to restore factory settings

135