Sony UWP-D27 2-Person Camera-Mount Wireless Omni Lavalier Microphone System (UC90: 941 to 960 MHz) - Manual (Page 438)

Help Guide
Interchangeable Lens Digital Camera
ILCE-7C α7C
ISO Setting: ISO
Sensitivity to light is expressed by the ISO number (recommended exposure index). The larger the number, the higher
the sensitivity.
Menu item details
ISO AUTO:
Sets the ISO sensitivity automatically.
ISO 50 – ISO 204800:
Sets the ISO sensitivity manually. Selecting a larger number increases the ISO sensitivity.
Hint
You can change the range of ISO sensitivity that is set automatically in [ISO AUTO] mode. Select [ISO AUTO] and press the right
side of the control wheel, and set the desired values for [ISO AUTO Maximum] and [ISO AUTO Minimum].
The higher the ISO value, the more noise will appear on the images.
The available ISO settings will differ depending on whether you are shooting still images, shooting movies, or shooting slow-
motion/quick-motion movies.
When shooting movies, ISO values between 100 and 102400 are available. If the ISO value is set to a value larger than 102400,
the setting is automatically switched to 102400. When you finish recording the movie, the ISO value returns to the original setting.
When shooting movies, ISO values between 100 and 102400 are available. If the ISO value is set to a value smaller than 100,
the setting is automatically switched to 100. When you finish recording the movie, the ISO value returns to the original setting.
The available range for ISO sensitivity varies depending on the setting for [Gamma] under [Picture Profile].
Note
[ISO AUTO] is selected when using the following functions:
[Intelligent Auto]
When the ISO sensitivity is set to a value lower than ISO 100, the range for recordable subject brightness (dynamic range) may
decrease.
When you select [ISO AUTO] with the shooting mode set to [P], [A], [S] or [M], the ISO sensitivity will be automatically adjusted
within the set range.
5-021-699-11(1) Copyright 2020 Sony Corporation
ISO (ISO) on the control wheel → select desired setting.
You can also select MENU → (Camera Settings1) → [ISO Setting] → [ISO].
You can change the value by 1/3 EV steps by turning the control wheel. You can change the value by 1 EV
steps by turning the control dial.
1
438