Configuring rai for dhcp over lan, Configuring rai over adsl – Enterasys Networks XSR-3150 User Manual
Page 49
Optional: Configuring Remote Auto Install
XSR Getting Started Guide 3-5
+
TFTP transfer succeeded in copying the hostname file to the
Flash:
startup-config
file.
****************** REMOTE AUTO INSTALL TERMINATING*****************
+
The RAI process is complete and is preoceding to system initialization where it will process the new
startup-
config
file.
Configuring RAI for DHCP over LAN
The following example configures DHCP server to be used with RAI over Ethernet. Note that
there is no need for a DNS server because the
startup-config
name is provided by the DHCP
server. Begin by creating an IP local pool which will include the Fast/GigabitEthernet interface
address:
XSR(config)#ip local pool dhcp 200.1.0.0 255.255.255.0l
Next, configure the interface that will service the remote device, set the IP address inside the pool
defined earlier, and enable DHCP Server:
XSR(config)#interface GigabitEthernet 2
XSR(config-if
XSR(config-if
XSR(config-if
Now configure the following DHCP Client parameters:
XSR(config)#ip dhcp pool dhcp
XSR(config-dhcp-pool)#lease 0 0 10
+
This command sets a lease interval of 10 minutes
XSR(config-dhcp-pool)#hardware-address 0001.f412.2334
+
This command sets the MAC address of the client
XSR(config-dhcp-pool)#host 200.1.0.66 255.255.255.0
+
This command binds 200.1.0.66/24 to the earlier configured hardware address
XSR(config-dhcp-pool)#option 12 instance 0 ascii etr1
+
This command sets the Client hostname as etr1
XSR(config-dhcp-pool)#option 150 instance 0 ip 1.1.1.1
+
This command configures the TFTP server IP address to 1.1.1.1
XSR(config-dhcp-pool)#option 67 instance 0 ascii etr1-startup-confg
+
This command enters the config-file name as startup-config
Remember to save your configuration after all edits.
Configuring RAI over ADSL
In the following example, a remote XSR is connected to an ADSL network at the central site with a
PPPoE server. A TFTP server runs on a separate machine - 192.168.72.118, while the PPPoE server
runs on a CISCO router. The PPPoE server can reside on any other device providing PPPoE
session termination and has a mechanism to direct TFTP broadcast packets to a specific IP address.
A DNS server is not required with this method because RAI over ADSL uses the serial number of
the XSR for the
startup-config
name.
The following is a CISCO configuration at the the central site:
vpdn enable
+
Enables a virtual private dial-up network configuration on the router.
vpdn-group 1