Enterasys Networks XSR-3150 - Manual (Page 37)

Installing a CompactFlash Memory Card
XSR Getting Started Guide 2-5
Installing a CompactFlash Memory Card
An optional CompactFlash (CF) memory card provides additional non-volatile storage
capabilities in 8, 16, 32, or 64 Mbyte increments. The CF’s controller interfaces with a host system
allowing data to be written to and read from the CF’s flash memory module. The XSR supports
Type I and II CompactFlash card types. Refer to
Figure 2-6 for a generic illustration of the card.
The CF’s memory is large enough to store image files. You can do so simply by using the Bootrom
Monitor mode
copy command. For example, to copy a file from the Onboard flash: directory to the
cflash: directory while in the flash: directory, enter:
XSR>copy cflash:
Figure 2-6 Typical CompactFlash Card
CompactFlash Card Installation
Follow the steps below to install the CompactFlash card:
1. If your CF is already formatted, first remove the cover plate as shown in Figure 2-7 . If it is not
formatted, jump to “Formatting the CompactFlash Card” on page 2-6.
Figure 2-7 Removing CompactFlash Coverplate
2. Seat the card in the PCMCIA interface as shown in Figure 2-8 .
Pin 50
Pin 1
NIM 1
NIM 2
1000
GBIC
Link
TX
10/1 00/1 000
10/1 00/1 000
SECURITY R
OUTERS XSR-3150
COM
PW R
SYS
NIM 1
NIM 2 VPN
COM
ETH3
ETH2
ETH1