ProSoft Technology MVI56E-61850S - Manual (Page 66)

Contents MVI56E-61850S ♦ ControlLogix Platform
User Manual IEC 61850 Server Communication Module
Page 66 of 81 ProSoft Technology, Inc.
September 4, 2014
6.1.1 Scrolling LED Status Indicators
The scrolling LED display indicates the module’s operating status as follows:
Initialization Messages
Code Message
Boot / DDOK Module is initializing
Ladd Module is waiting for required module configuration data from
ladder logic to configure the ports
Waiting for Processor Connection Module did not connect to processor during initialization

Sample ladder logic is not loaded on processor
 Module is located in a different slot than the one
configured in the ladder logic
 Processor is not in RUN or REM RUN mode
Last config: Indicates the last date when the module changed its IP
address. You can update the module date and time through
the
Connect to the Module’s Web Page (page 78), or in
MVI56E-61850S controller tags.
Operation Messages
After the initialization step, the following message pattern will be repeated.
Code Message
OK: Module is communicating with processor
ERR: Module is unable to communicate with processor. For
this scenario, the message above is replaced
with "Processor faulted or is in program mode".
Module IP address
OK: Port is communicating without error
Client/Server Communication Errors: port is having
communication errors. Refer to Diagnostics and
Troubleshooting (page 65) for further information about the
error.