PLANET IKVM-17080 - Manual (Page 50)

Remote Console And
HTTPS port Port number at which the IP-KVM's Remote Console
server and HTTPS server are listening. If left empty the
default value will be used.
HTTP port Port number at which the IP-KVM's HTTP server is
listening. If left empty the default value will be used.
Telnet port Port number at which the IP-KVM's Telnet server is
listening. If left empty the default value will be used.
SSH port
Port number at which the IP-KVM SSH (Secure SHell)
server is listening to. If left empty the default value (port
22) will be used.
Bandwidth limitation
The maximum network traffic generated through the
IP-KVM ethernet device. Value in Kbit/s.
Enable Telnet access
This enables the Telnet function.
Enable SSH access
This enables the SSH (Secure SHell) function.
Disable Setup
Protocol
Enable this option to exclude the IP-KVM from the
setup protocol. Setup protocol is a proprietary layer-2
MAC-based protocol to allow some configuration
software to detect IP-KVM devices in the network, even
without IP address, and then config network related
settings to IP-KVM.
43B
5.5.2 Dynamic DNS
A freely available Dynamic DNS service (www.dyndns.org) can be used in the following
44