PLANET MH-1000 - Manual (Page 54)

Multi-Homing Security Gateway User’s Manual
4.4.3.4 Protocol Binding
Protocol Binding lets you direct specific traffic to go out from a specific WAN port. Click the Create button to
create a new policy entry. Policies entered would tell specific types of Internet traffic from a particular range
of IPs to go to a particular range of IPs with ONE WAN port, rather than using both of the WAN ports with
load balancing.
(NOTE: If any policies are added in the Protocol Binding section, please note that it would take precedence
over the settings that are already configured in the Load Balance Setting section.)
ÍÍ
The Protocol Binding Table lists any protocol binding that has been configured. To add a new binding, click
Create .
Interface: Choose which WAN port to use: WAN1, WAN2
Source IP Range:
- All Source IP: Click it to specify all source IPs.
- Specified Source IP: Click to specify a specific source IP address and source IP netmask.
Source IP Address: If Specified Source IP was chosen, here’s where the IP can be entered.
Source IP Netmask: If Specified Source IP was chosen, here’s where the subnet mask can be entered.
Destination IP Range:
- 50 -