PLANET MH-1000 - Manual (Page 29)

Multi-Homing Security Gateway User’s Manual
3.4 Factory Default Settings
3.4.1 User name and password
The default user name and password are "admin" and "admin" respectively.
If you ever forget your user name and/or password, you can restore your MH-1000 to its factory settings by
holding the Reset button on the back of your router until the Status LED begins to blink. Please note that
doing this will also erase any previous router settings that you have made. The Status LED will remain solid
as the device boots. Once the boot sequence is complete, the LED will shut off, indicating that MH-1000 is
ready.
3.4.2 LAN and WAN Port Addresses
The default values for LAN and WAN ports are shown below:
LAN Port WAN Port
IP address
192.168.1.1
Subnet Mask
255.255.255.0
DHCP server
function
Enabled
IP addresses for
distribution to
PCs
100 IP addresses continuing
from 192.168.1.100 through
192.168.1.199
The DHCP Client is enabled to
automatically get the WAN port
configuration from the ISP.
3.5 Information from Your ISP
3.5.1 Protocols
Before configuring this device, you have to check with your ISP (Internet Service Provider) to find out what
kind of service is provided such as DHCP, Static IP, PPPoE, or PPTP. The following table outlines each of
these protocols:
DHCP
Configure this WAN interface to use DHCP client protocol to get an IP
address from your ISP automatically. Your ISP provides an IP address to the
router dynamically when logging in.
Static IP
Configure this WAN interface with a specific IP address. This IP address
should be provided by your ISP.
PPPoE
PPPoE (PPP over Ethernet) is known as a dial-up DSL or cable service. It is
designed to integrate the broadband services into the current widely
deployed, easy-to-use, and low-cost dial-up-access networking
infrastructure.
- 25 -