PLANET ADE-3400 - Manual (Page 47)

The following table describes the parameters and buttons of this page:
Field Description
IP QoS
Select to enable or disable IP QoS function. You need to enable IP
QoS if you want to configure the parameters of this page.
QoS Policy You can choose stream based, 802.1p based, or DSCP based.
Schedule Mode You can choose strict prior or WFQ (4:3:2:1).
Source IP The IP address of the source data packet.
Source Mask The subnet mask of the source IP address.
Destination IP The IP address of the destination data packet.
Destination Mask The subnet mask of the destination IP address.
Source Port The port of the source data packet.
Destination Port The port of the destination data packet.
Protocol
The protocol responds to the IP QoS rules. Y ou can choose TCP,
UDP, or ICMP.
Physical Port The LAN interface responds to the IP QoS rules.
Set priority
The priority of the IP QoS rules. P0 is the highest priority and P3 is
the lowest.
IP Precedence
You can choose from 0 to 7 define t he priority in the T oS of the IP
data packet.
IP ToS
The type of IP ToS for classifying the data package
You can choose Normal Ser vice, Mi nimize Cost , Maximize
Reliability, Maximize Throughput, or Minimize Delay.
802.1p You can choose from 0 to 7.
delete Select a row in the QoS rule list and click it to delete the row.
delete all Select all the rows in the QoS rule list and click it to delete the rows.
3.6.4 SNMP
Choose Advance > SNMP , the p age shown in the follo wing figure appears. Y ou can
configure the SNMP parameters.
The following table describes the parameters of this page:
Field Description
Enable SNMP
Select it to enable SNMP function. You need to enable
SNMP, and then you can configure the p arameters of
this page.
Trap IP Address
Enter the trap IP address. The trap information is sent
to the corresponding host.
47