PLANET ADE-3400 - Manual (Page 31)

The following table describes the parameters of this page:
Field Description
Default Route Selection You can select Auto or Specified.
VPI
The virtual path between two poi nts in an ATM network,
ranging from 0 to 255.
VCI
The virtual channel between two points in an ATM
network, ranging from 32 to 655 35 (1 to 31 are reserved
for known protocols)
Encapsulation You can choose LLC and VC-Mux.
Channel Mode
You can choose 1483 Bridged , 1483 MER , PPPoE,
PPPoA, or 1483 Routed.
Enable NAPT
Select it to enable Network Address Port T ranslation
(NAPT) function. If you do not select it and you want to
access the Internet normally, you must add a route on the
uplink equipment. Otherwise, t he access to the Internet
fails. Normally, it is enabled.
Enabel IGMP
You can enable or disabl e Internet Group Management
Protocol (IGMP) function.
PPP Settings
User Name
Enter the correct user name for PPP dial-up, whic h is
provided by your ISP.
Password
Enter the correct p assword for PPP dial-up, which is
provided by your ISP.
Type
You can choose Continuous, Connect on Demand , or
Manual.
Idle Time (min)
If set the type to Connect on Demand, you need to enter
the idle timeout time. Within the preset minutes, if the
router does not detect the flow of the user continuously ,
the router automatically dis connects the PPPoE
connection.
WAN IP Settings
Type
You can choose Fixed IP or DHCP.

If select Fixed IP , you should enter the local IP
address, remote IP address and subnet mask.

If select DHCP, the router is a DHCP client, the WAN
31