PLANET ADE-3400 - Manual (Page 33)

Field Description
idle timeout time. Within the preset minutes, if the router
does not detect the flow of the user continuously , the
router automatically disconnects the PPPoE connection.
Bridge
You can select Bridged Ethernet, Bridged PPPoE, or
Disable Bridge.
AC-Name The accessed equipment type.
Service-Name The service name.
802.1q
You can select Disable or Enable. After enable it, you
need to enter the VLAN ID. T he value ranges from 0 to
4095.
Apply Changes Click it to save the settings of this page temporarily.
Return Click it to return to the Channel Configuration page.
Undo Click it to refresh this page.
3.4.2.2 ATM Setting
Click ATM Setting in the left pane, the page shown in the following figure appears. In this
page, you can configure the p arameters of the ATM, including QoS, PCR, CDVT , SCR,
and MBS.
The following table describes the parameters of this page:
Field Description
VPI The virtual path identifier of the ATM PVC.
VCI The virtual channel identifier of the ATM PVC.
QoS
The QoS category of the PVC. Y ou can choose UBR, CBR,
rt-VBR, or nrt-VBR.
PCR
Peak cell rate (PCR) is the maxi mum rate at which cells can be
transmitted along a c onnection in the A TM network. It s value
ranges from 1 to 65535.
CDVT
Cell delay variation tolerance (CDVT) is the amount of delay
permitted between ATM cells (in microseconds). Its value ranges
from 0 to 4294967295.
SCR
Subtain cell rate (SCR) is the maximum rate that traffic can pass
over a PVC without the risk of cell loss. Its value ranges from 0 to
65535.
MBS
Maximum burst size (MBS) is the maximum number of cells that
can be transmitted at the PCR. Its value ranges from 0 to 65535.
33